Ares Chronos FP 110 Manual de Instruções descarregar pdf (Página 23)

Flying (General)

Now that you’ve selected a suitable ying area you’re

ready to y! And when making your rst ights we suggest

following these steps:

•With the mode switch is 6-axis mode (down) slowly raise

the le-hand/throle sck to increase the speed of the main

rotor blades and unl the model begins to li o. Do NOT

raise the sck too quickly as the model could climb too

fast causing you to lose control and/or make contact with

the ceiling or other objects above (this is one of the most

common ways for many pilots to crash the rst me!).

• Li the model approximately 20–24 inches (50–60

cenmeters) o the ground and concentrate on ‘balancing’

the throle sck posion so the helicopter holds a steady

hover altude. It may also be helpful to make a few short

‘hops’ to an altude of just a few inches unl you’re familiar

and more comfortable with the control inputs and trim

sengs required to maintain a steady hover and altude.

However, keep in mind that when only a few inches o

the ground you’ll be in ‘ground eect’ which will cause the

helicopter to move around more than it typically would at

approximately 20–24 inches of altude.

• You’ll nd that it somemes takes minor throle

adjustments to maintain altude in hover. Remember to

keep these adjustments as minimal as possible as large

adjustments could result in a loss of control and/or a possible

crash.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 31 32

Sem comentários

Ares Chronos FP 110 Manual de Instruções Página 23