Ares Chronos FP 110 Manual de Instruções descarregar pdf (Página 24)

• While aempng to establish a low-level hover out of

ground eect (approximately 20–24 inches high or higher)

you can check to see if any trim adjustments are required to

help keep the helicopter from constantly driing in various

direcons. If you nd that the helicopter constantly dris

without any direconal control input it may be best to

land the model before making any adjustments to the trim

sengs using the trim levers on the transmier (you can

nd more informaon regarding the locaon and funcon of

the trim in the ‘Flight Controls and Trimming’ secon of this

manual).z

• If the helicopter is driing forward or backward adjust the

elevator trim.

• If the enre helicopter is driing to the le or right adjust

the aileron trim. It’s important to connue making trim

adjustments as needed unl the helicopter can hover at an

altude of approximately 20–24 inches (or higher) with very

lile driing or direconal control input. And while it’s not

possible to eliminate all driing completely using the trims it

is possible to get very close. Also, if this is your rst FP (Fixed-

Pitch) helicopter model it may be best to enlist the help of an

experienced pilot to trim the model for you before making

your rst ight.

• When the helicopter is properly trimmed, maintain a

stable hover and pracce using the rudder, elevator and

aileron controls to get a feel for how the helicopter responds

to various control inputs. Remember to keep the control

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 30 31 32

Sem comentários

Ares Chronos FP 110 Manual de Instruções Página 24